Removing Sediment in Your Charleston SC Water Heater

Posted by on Dec 13, 2013 in Water Heater Repair Charleston SC | 0 comments

If you have a trouble with sediment, you’re probably already knowledgeable about it. Gas fired water heaters in particular commonly show that there is a sediment problem with rumbling sounds each time the tank cycles, while still maintaining good water temperature. Fortunately, sediment in your hot water tank can easily be flushed out, keeping the functionality of your heater.

Water Heater Repair Charleston SC

Water heater (Photo credit: km6xo)

If you have a gas water heater, turn the control to pilot. If you have an electric design, you need to switch off the electrical energy at the panel. Next shut off the water above the heater so no brand-new water can get in the tank. Then connect a hose to the drain valve. The various other end of the hose ought to preferably go to a floor drain, although a pail can also be made use of.

Open the drain valve to eliminate all the water from the tank. The majority of the sediment ought to be eliminated by this simple act. Keep the drain valve open, but turn on the water also, permitting some to enter the tank. Turn off the water after a couple of moments. Repeat this numerous times to coax as much sediment out with the water.

As a last measure, close the drain and fill the tank a minimum of half full. Then you can drain it for a final time to eliminate any last bits of sediment. To prevent further common sediment troubles, you can set up a sediment filter for your tank if your issue is mostly with sand. A sand filter must be installed on the cold trunk line.

Occasionally sediment can also congest the drain valve itself. Ideally you ought to be able to wash the valve out under high pressure, however in some cases the valve requires to be replaced after a cleaning. You can achieve this job while the tank is still full, simply shut off the gas or power and await the water in the tank to cool. You should also not use any water in your house will completing the replacement.

To get rid of the drain valve, simply use a large groove joint pair of pliers to turn off the old valve. Then install a replacement valve by twisting it in clockwise. Make certain to use pipe thread sealing tape or pipe joint compound on the threads to ensure that the connection will hold water.

If you are planning to get rid of the drain valve, you could think about before installing the replacement valve offering your tank a last flush. This is best done if you have a floor drain that will rapidly drain the water and sediment.

Many individuals incorrectly think that a sediment filled tank or a dripping drain valve is source to change the entire hot water heater. By these simple upkeep steps, many residents need to have the ability to take care of any troubles on their own. Naturally, if you run into various other troubles while finishing this repair, call a plumbing technician who will have the ability to quickly take care of the issue.

Water Heater Repair Charleston SC invites you to read more from us:

 Charleston SC Water Heater Costs

Charleston SC Water Heater Safety Precautions

How to Fix a Leaking Charleston Water Heater

Enhanced by Zemanta